tyc@cbnewse.att.com (felix.a.lugo) (05/03/91)
To clear up some misunderstandings with the settings in the "p" command of the NeXT monitor (these settings are only required for the system board that doesn't have the NeXT display monitor connected): 1. Sound out test must be "no"; the boot process will not proceed if the monitor isn't connected to the board and this is set to "yes". 2. SCSI tests should be "no" if you don't have SCSI devices attached to the board. 3. Verbose test mode must be "no" for booting from the network. If set to "yes", the boot process will timeout waiting for a BOOTP and you'll be left in the monitor with no means of restarting the board (except pulling the power plug!) This is probably true also for booting from an OD that hasn't been inserted (assuming the OD was attached to the board). 4. Allow serial port A as alternate console if you want to view the boot process (for problems and peace-of-mind). 5. Other settings were not modified from their factory defaults or had no effect on the procedure. =============================================================================== Felix A. Lugo E-Mail: (NeXTmail preferred) AT&T Bell Laboratories, Naperville, IL Felix_A_Lugo@ATT.COM coco@ihcoco.att.com AT&T NeXT User Group nug@ihcoco.att.com T.Y.C. Software, Lisle, IL coco@ihtyc.att.com ===============================================================================