kklw@mullian.ee.mu.OZ.AU (Kevin K L WONG) (11/04/89)
We just bought the Schema II+ (from Omation) and the Xilinx PCA development system, XACT. There are few questions I want to ask: 1. After quitting from xact, the keyboard reset (CTRL-ALT-DEL) no longer works. It gives an error message of "DOS/16M: Protected Mode Failure" and the PC then just stuck so I have to do a hardware reset. What is the problem? 2. For Schema, when I start the SCHDRAW, it gives an error message of "/1 LIBRARY NOT FOUND". I check the configurations, all 9 libraries are set properly and I can call components from all 9 of them. Any suggestions where has gone wrong? 3. Are there any technical support from Omation or Xilinx down here in Australia? Where can get hold of them (Email addresses)? Thank you in advance. |~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~|~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~| | Kevin WONG | ACSnet : kklw@mullian.mu.oz | | Department of Elec Engineering | internet : kklw@mullian.mu.oz.au | | University of Melbourne | uunet : uunet!munnari!mullian!kklw |