was@gdwb.oz.au (Warren Stokes) (07/31/90)
I am using PC-NFS 3.0.1 with a 3C503 board using the packet driver "glue" PKTD.SYS out of compat.tar.Z from clarkson. I changed the jumpers on the board to use shared memory and installed the packet driver 3C503.COM from drivers. PC-NFS works just fine. However, NCSA telnet works but is hanging PC-NFS after exitting from telnet. I have set CONFIG.TEL to use the hardware option of 3C503. This implies it is using the hardware directly and leaving it in a funny state. The other option in CONFIG.TEL is to specify hardware=packet. I get the following messages: NCSA Telnet 2.3b8, reading configuration file . . . Marning, packet driver vector invalid, using default search W Packet Access Type Error 10 Can't Access IP handle interface type 1 Packet driver probably not loaded Packet Access Type Error 10 Can't Access IP handle interface type 1 Packet driver probably not loaded Board initialisation failed! Error code=2 Error initialising network or getting configuration file Cannot initialise board. The essential bits of my autoexec.bat are: 3C503 0x60 3 0x300 0 and my config.sys: device=pcnfs.sys device=sockdrv.sys device=pktd.sys Has anyone any ideas on this? Does documentation exist for NCSA Telnet 2.3b8 yet? Will Sun be releasing a version of PC-NFS which will allow third party telnets (and other goodies) to sit on top their drivers? Warren Stokes Geelong Water Board, Australia. was@gdwb.OZ.AU