iv@cs.odu.edu (Boyd C Fletcher Iv) (02/28/90)
I am considering purchasing a Everex RAM 3000 expanded memory board. Does anyone one no anything about it? Will it it will DesqView 286 and MS Windows 286 v2.11? I am running an AT Compatible 286 @ 12Mhz with 1 meg on board (384k extended) using MSDOS 4.01. Also.... I am in dire of the source code for any VT100 or higher terminal emulation. I am writing a Terminal Program in Turbo Pascal 5.0 (5.5) and would perfer the source in Pascal but C would be ok. If anyone has the ESC Codes (all of them inlcuding CTRL's if any) I would greatly appreciate anyone sending me the information. Thanks, Boyd Fletcher ----------------------------------------------------------------------------- | Boyd C. Fletcher IV | Internet iv@cs.odu.edu | ----------------------------------------------------------------------------- | "It's very difficult to be consistently funny and consistently careful." | ----------------------------------------------------------------------------- | "Be excellent to each other" | -----------------------------------------------------------------------------
phil@pepsi.amd.com (Phil Ngai) (02/28/90)
If you are looking to do multitasking with DV, my best advice is to get
something which does EEMS. Note that EMS 4.0, although a later spec,
is a much less useful spec in that you can palm almost anything off as
EMS 4.0.
Do not buy a 286 with a NEAT chipset if you want to multitask.
You will probably end up with a 386sx as I did.
(your specified configuration is hopeless)
--
Phil Ngai, phil@amd.com {uunet,decwrl,ucbvax}!amdcad!phil
A PC without DESQview is like Unix without ^Z.