gregb@dowjone.UUCP (Greg_Baber) (09/20/88)
Hello, I am trying to install the Kinetics EtherportII on my Mac II with A/UX, and I got to the point (page 2-12 in the Network System Administration manual) where after the new kernel reboots, it is supposed to prompt me for the hostname, domainname, etc. After I try both of the procedures they list for doing the system config, and issue the reboot command, I get a warning message about the system not being able to find some device drivers, I see the line about the loopback address lo0 being up and running, but I never get the prompts. I installed the Ethernet hardware under the MacOS, so maybe the drivers never got onto the right partition??? Anyone familiar with this setup, or who has seen this type of error before, able to help me? Please respond by E-mail or voice, I'll call you back if by voice. Thanks, gregb -- Reply to: Gregory S. Baber Voice: (609) 520-5077 Dow Jones & Co., Inc. E-mail: ..princeton!dowjone!gregb Box 300 or ..uunet!dowjone!gregb Princeton, New Jersey 08543-0300