david@uhccux.uhcc.hawaii.edu (David Lassner) (06/24/89)
I just brought A/UX 1.1 up on a new cx and can't seem to get it to know what time it is. I've got my NVRAM clock set ok. The GMT offset in the SASH settings is ok (-10 hrs / 600 minutes). And the date command in SASH knows what time it is just fine, although it reports the current PDT time. But regardless of what I put in /etc/zoneinfo/localtime and /etc/TIMEZONE I get a time from A/UX which isn't obviously related to the MacOS time or SASH time. I.e. even the minutes are wrong. However it does pick up the alpha for the time zone (HST) correctly. If I issue a new date command to reset the time for A/UX, it immediately reports back a time which is off by 30 minutes from the time to which I just set it. I must be missing something obvious, but I sure can't find it in either the Installation Guide or Local System Admin Manual. Will appreciate any suggestions. -- David Lassner, University of Hawaii Computing Center, 808/948-7351 INTERNET: david@uhccux.uhcc.hawaii.edu BITNET: david@uhccux