ira@iear.arts.rpi.edu (Ira Lee) (09/12/90)
I just purchased A/UX 2.0 Tape Product and am attempting to install it now. I have come across a problem, perhaps anyone out there that has done a tape installation can help me: I used Silverlining to create the "AUX 2.0 min mac partitions" then ran the AUX install program that came with the product. I followed the instructions...first putting in the Floppy Root disk and waited for the program to create some needed directories,etc. After this was done, the install program told said that it would restart now and to find a program called read_disk in the MacPartition, and run that to load the Kernal Archive floppy. After restarting, I couldn't find the read_disk program anywhere on my disk. Is there somehting I am doing wrong? Where is the read_disk program?-I figured the install program would have installed that on to my hard drive. Any help would be greatly appreciated. Thanks in advance. ira bye Ira Lee iradx7@pawl.rpi.edu ira@iear.arts.rpi.edu (518) 276-IRAS (718) 279-4814