[comp.sys.amiga.tech] Sculpt-Animate 1/2 Brite?

ULC@PSUVM.BITNET (11/13/88)

I have a bit of a problem... I recently obtained an old A1000 to do number
crunching via Scuplt-Animate 3/4D . Unfortunatly the brightness of the output
does not seem at all equal to that of my A500. The intensity range is much smal
ler and in fact even the WB preferences colors seem very limited either being
bright (fully on) or off (1/2 way down the slider).. I use the same moitor fot
for both computers???? Does the absence of the 1/2 brite chip make this differe
nce or is there an internal control to adjust this. It  becomes really
annoying when after spending 5hrs raytracing a picture only to discover that
it is horribly overexposed by viewing it on my A500...???


                                                 Any suggestions??

                                    Thanks in advance...
                                                 Jason Twamley
Ps.  If indeed I need a 1/2 brite chip..is it easy to put in & can I get it?
     (I am an EE grad..)