mmartin@nmsu.edu (Marilyn Martin ) (05/09/90)
I just installed 2M on my 2091 card. Used mergemem to address it. Shows up on status line in Workbench and status line in Sculpt 4D. BUT when Sculpt tries to access RAM over standard 3M (2500/30) IT CRASHES! Avail shows RAM as being there. But Ramtest (whatever the name of that utility is that comes with Workbench 1.3) says BAD BIT at all the addresses. Help! Signed, megadespair Marilyn Martin NMSU Computer Center LAs Cruces NM 88003 505-646-1840 (for those of you with a watts line)