IO91461@MAINE.BITNET (Tom Nezwek) (07/26/90)
Hello,
I recently put a 2nd floppy (chinnon FB-354 intended for ibm
clone use) in my 2500. It had no drive select jumpers on it so I used
one of those adaptor cards that supplied the jumpers, but also turned
the pin type conector into a flat edge connector. No problem I just
installed a flat edge socket-type connector to the amiga ribbon cable
When I boot up with a disk in df1: all is fine only that when I pop
out the disk and put in another, the amiga does not perform the disk
change operation. SO it thinks the origonal disk that I booted up
with is still in df1:.... What's the deal here? When I use Project D
to back-up a disk, df1: does disk changes and appears to work fine..
(Yes I have removed the jumper on the Mother board telling it that
a second floppy is installed) Please send me some E-mail if you
know anything about this problem...
-Thanks
-Tom Nezwek IO91461@maine.bitnet