gsbrob1@apcvxa.uchicago.edu (11/25/88)
I've written a short application in LSP and I'm having a problem: When I've built and saved the application and open up a DA from within the application, the DA opens but the floppy drive in which the system disk is keeps on spinning even after the DA is loaded. I checked with TMON, and if I step through the application, the drive spins for a short (1 sec) interval every time SystemTask is called, and then stops. Since SystemTask is being called so often (once each time through the loop), the consequence is non-stop spinning when the application is running. Other than that it seems to go through the event loop fine: one can pull down menus, etc. The spinning doesn't happen when the application is running in the LSP environment. Where should I begin looking for the problem? I first built the app in LSP 2.0, which may be a bit buggy, from what I've heard, so I went and re-built it in 1.11. Same problem. It also doesn't seem to be that particular DA, since it happens with several (and the DA's work fine in all other circumstances) Thanks for any info, Robert --------------------------- gsbrob1@apcvxa.uchicago.edu ra_robert@gsbacd.uchicago.edu ............................................................................ . generic disclaimer: all opinions here expressed are mine and mine alone . ............................................................................