rees@usage.csd.unsw.OZ.AU (Rees Griffiths) (05/05/90)
I was wondering if any one could provide me with some pointers to
writing a string into the chooser name from an application. The
following code seems capable of finding the right 'STR " resource. But
I'm really not sure where to take it from there.
Hndl&=FN GETRESOURCE(1398034976,-16096)
RefNum%=FN HOMERESFILE(Hndl&)
Rsize% =FN SIZERESOURCE(Hndl&)
I don't normally read this newsgroup, however as I have just run into
this problem I grep'd this newsgroup to check if the problem had cropped
up recently, which it had. The discussion seemed to mostly centre around
Responder init though.
I need to write the chooser name for use in a lab environment, much
as mmcintos@uvicctr.UVic.CA.UUCP (who started the discussion does). I
already have an application that is used for other purposes I wish to add
this code segment to it.
Any advice gratefully accepted.
Please email to bi_rees@vaxa.mqcc.mq.oz.au (or the above address)
Rees
_________________________________________________________________________
Snail: Mr Rees Griffiths, School of Biological Sciences,
Macquarie University, N.S.W., Australia, 2113
Phone: (02) 805 8202 Facsimile: (02) 805 <<<<<<<>>>>>>>
Int. +61 2 805 8202 +61 2 805 <<<<<43.2>>>>>
email bi_rees@vaxa.mqcc.mq.oz.au <<<<<<<>>>>>>>
*************************************************************************
"There you stand like a duck in a thunderstorm again,
aren't you ever going to understand". W.A. MOZART.
*************************************************************************