john@wa3wbu.UUCP (John Gayman) (12/22/88)
Yes, yet another edition to the continuing saga. Although this may very well be the last chapter. :-) I finally got Elm working with Smail and V/386. Someone had suggested that I specify SVR2 instead of SVR3 in the Configuration routine. I had initially tried this with no luck. Tonight, however, I removed everything and re-unshared the source and started out fresh specifying SVR2. ANd it works!! I don't quite recall who suggested doing that but I thank you. Apparently something wasn't getting changed properly by re-running Configure. So now I'm back to my good 'ol Elm just like before. I appreciate all the help and suggestions, Including offers of assistance from Microport despite the fact this is no problem on thier part. There is definately a learning-curve in going from Sys V/AT to V/386 and little by little things will begin falling into place. John -- John Gayman, WA3WBU | UUCP: uunet!wa3wbu!john 1869 Valley Rd. | ARPA: john@wa3wbu.uu.net Marysville, PA 17053 | Packet: WA3WBU @ AK3P