eastick@me.utoronto.ca (Doug Eastick) (10/11/90)
I bought a truckload of 4D25's. The 3.3.0 O/S was loaded before I got them and I only got 3.2.1 tapes (loading done by a middle-corp). I'd like to know if I was supposed to get the binaries for uucp and cu in particular. Or, is it on a 3.2.1 tape I can snarf it off of. I'm trying to hook up a laserwriter to a 4D25S and no luck so far. If I had cu I'd at least be able to talk to it. Any suggestions welcome.
bobg@rains.wpd.sgi.com (Bob Green) (10/11/90)
In article <90Oct11.064747edt.19184@me.utoronto.ca>, eastick@me.utoronto.ca (Doug Eastick) writes: |> I bought a truckload of 4D25's. The 3.3.0 O/S was loaded before I got |> them and I only got 3.2.1 tapes (loading done by a middle-corp). I'd like |> to know if I was supposed to get the binaries for uucp and cu in particular. |> Or, is it on a 3.2.1 tape I can snarf it off of. |> The 'cu' and 'uucp' utilities are part of the eoe2.sw.uucp sybsystem. Since they are not installed by default you will have to use the manual mode of the installation tools to grab them from the tape. If you have 3.3 installed on your system them you should have 3.3 + 3.3.1 tapes and documentation. Do not try to pull files from a 3.2.1 tape onto your 3.3 system. Bob Green Silicon Graphics