brahms@spp2.UUCP (12/11/84)
[}{]
Is anyone using a Hayes smartmodem on a 3b2 to do both dialing in and out
of the computer? I am having problems getting ours working correctly.
What are the switch settings that you are using? What does your
/etc/inittab entry for the line look like? How about L-devices and
L-dialers? Protections, etc. anything that I could have overlooked.
In most cases, it works for dialing in (it does fail sometimes and when
it does, it turns off HS 1200 (baud mode)). However, I am unable to
get it to dial out at all. When I set level 3 in inittab (as the
documentation says to use), cu sits around, not sending anything to the
modem, until it tells me "connect failed". If however, I use level 2,
then I get the following error message:
getty: cannont open "acu0". errno: 4
I have checked the different L-* files and all seem to be okay. Any help
that you can give me would be appreciated. Thanx.
-- Brad Brahms
usenet: {decvax,ucbvax}!trwrb!trwspp!brahms
arpa: Brahms@usc-eclc
P.S. Where in the documentation does it describe what error numbers
are for what errors? In the above case, for open().