hugo@spica.ucsc.edu (Hugo Calendar) (08/04/90)
Yep, I did devices... Informations is being sent through the cable, so something is working. Does anybody have a sample file that I should be able to send to the 3812 printer from an RT? Thanks, -Hugo Hugo Calendar ...!ucbvax!ucscc!spica!hugo 215 Weeks Avenue hugo@spica.ucsc.edu Santa Cruz, CA 95060 hugo@ucscd.bitnet (408) 425-5479
karish@mindcrf.UUCP (08/06/90)
In article <5751@darkstar.ucsc.edu> hugo@spica.ucsc.edu (Hugo Calendar) writes: >Yep, I did devices... Informations is being sent >through the cable, so something is working. Did you use `devices' to configure the line for a tty or for a printer? These are different. Did you check the settings of the DIP switches inside the back cover of the printer? The printer manuals tell what they do. >Does >anybody have a sample file that I should be able >to send to the 3812 printer from an RT? '/bin/print file' should work for any ASCII file. -- Chuck Karish karish@mindcraft.com Mindcraft, Inc. (415) 323-9000
BLI@psuvm.psu.edu (JEFF BRENDLE) (08/07/90)
There is a second diskette that you must install in the 3812 for it to work with the 6150...of course ours isn't working yet either, so....try something/ try everything until it does I guess is the best I can tell you, but we DID replace the diskette with one labeled "IBM 3812 RT" :-) -J
karish@mindcrf.UUCP (08/08/90)
In article <90219.110715BLI@psuvm.psu.edu> BLI@psuvm.psu.edu (JEFF BRENDLE) writes: >There is a second diskette that you must install in the 3812 for it to work >with the 6150... Ours says "P/N 11F7734 EC A74721 V2.01 07-28-1988" >of course ours isn't working yet either, so....try something/ >try everything until it does I guess is the best I can tell you ... The printer here has been running for a year and a half with no attention other than replacing expendable parts (some of them EXPENSIVE). All I had to do to get it going was 0) Unpack the printer and plug it in. 1) Put in the correct diskette. 2) Change one of the DIP switches. 3) Run `devices' to tell the system that I had a printer, not a terminal, on the serial line. I fussed with the /etc/qconfig file a bit, but I think that the stanza `devices' installed would have worked unchanged. -- Chuck Karish karish@mindcraft.com Mindcraft, Inc. (415) 323-9000