gutherz@athos.rutgers.edu (Matt Gutherz) (11/16/88)
Like the subject says "help". Has anyone gotten this to combo to work? The ps/2 is a model 80. The telnet is version 2.2 off a work AT/3c501 combo. It starts fine, reads the config.tel, then displays a consol message that end in "press alt-H for help" and the hangs. Is it something in the config file or is it the executable Thanks for you input in advance, Matt Gutherz gutherz@jove.rutgers.edu
timk@NCSA.UIUC.EDU (Tim Krauskopf) (11/21/88)
The most probable cause for the 3C523 not working for NCSA Telnet is not having the config.tel file configured with: address=c000 ioaddr=2300 Note that the address is the shared memory SEGMENT, four hex digits. These two values must match what you selected in the configuration step when you installed the board. I apologize for not using the POS, we always seem to be in a rush when it comes to new drivers. Tim Krauskopf timk@ncsa.uiuc.edu (ARPA) National Center for Supercomputing Applications (NCSA) University of Illinois, Urbana-Champaign