EE5990038@RVAX.CCIT.ARIZONA.EDU (Paul Charette) (12/08/89)
I am working with NNCSA Telnet version 2.3beta on an Intel System 310 (PC compatible) under MS-DOS version 3.3 with an Etherlink 3C503 card. I managed to get the NCSA stuff working with the 3C503 "packet driver" stuff. However, I can't seem to get it to work without the packet driver (hardware= 3c503). I was wondering how I would need to configure my system if I wanted to run without thepacket driver mode. Is the 3c503 driver internal to TELBIN.EXE? When I try to run telbin.exe with the following in my config.tel file: hardware=3c503 interrupt=3 address=cc00 ioaddr=300 Without installing the 3c503 TSR (what _does_ TSR stand for?), I get the following error message: error from dlayerinit()=-1 Any ideas what's happening here? Also, is there any comprehensive documentation about NCSA Telnet V2.3beta? I have some bits and pieces about how to use it, but I would like to know how it works a little better (I guess I _could_ read the code ;-). ANYhow, thanks in advance for any help ... Paul Charette Department of Electrical and Computer Engineering University of Arizona " "