dumas@EUROPE.CISCO.COM (Jean-Pierre Dumas) (07/30/90)
I am trying to set up and use the KA9Q package on a Mac. And I do not succeed... I use currently NCSA 2.3 on the same Mac, without too many problems. (The handling of ^C is a problem, but this is an other story.) I am on the LocalTalk, with a Gator box to the local Ethernet. I have too an Asynch connection to a Terminal Server to be used with SLIP or straight terminal connection. (I'd love too to have a SLIP driver on the Mac for KA9Q.) I used to have NET or NOS on a PC, with a 3com card on Ethernet, works OK. Can some kind soul tell me what is wrong with my setup ? And/Or point me toward a better, more recent version ? Regards, Jean-Pierre Dumas dumas@cisco.com The binary is : KA9Q 871225.33 Alpha 4 Here is my Autoexec.net file : ++++++++++++++++++++++++++++++++++++++++++ hostname MYMAC ax25 mycall MYMAC # The following describes the parameters for the AppleTalk driver. # # argv[0]: hardware type, must be "appletalk" # argv[1]: Protocol Type, e.g., "77" # argv[2]: device name,must be "b" # argv[3]: mode, must be "arpa" # argv[4]: interface label, e.g., "at0" # argv[5]: maximum number of packets allowed on receive queue, e.g., "5" # argv[6]: maximum transmission unit, bytes, e.g., "600" < appletalk limitation. # attach appletalk 77 b arpa at0 5 600 # # Insert your personal IP address in []'s: # ip addr [131.108.10.31] # # By default all packets will go out the "ax0" port: # route add default at0 # ip ttl 16 # tcp mss 216 # tcp window 432 # tcp irtt 5000 # log :spool:log # start smtp start ftp start echo start discard start telnet start finger # smtp timer 180 # #escape ` # # Set the local timezone and offset to GMT # tzone MET -1