oracle@dayton.saic.com (11/14/90)
I am attempting (w/o success) to run NCSA Telnet 2.3b11 on my
AST Premium 286 machine configured as follows:
3COM 503 Ethernet Board
Ethernet Thinwire Connection
CONFIG.TEL contents:
myip=139.121.20.112 # Provided by Local Administrator
netmask=255.255.255.224 # Provided by Local Administartor
arp=3
tek=no
video=ega
bios=no
hardware=3c503
interrupt=3
ioaddr=300 # Provided by Local Administrator
wire=thin
gateway=1
rwin=512
mtu=512
maxseg=512
termtype="vt100"
I attempt to start telnet with the following command:
C:> TELNET 139.121.20.97
139.121.20.97 is the IP address of our VAX.
I receive the following error message(s):
NCSA Telnet 2.3b11, reading configuration file . . .
MyIpString=[139.121.20.112]
Error initializing network or getting configuration file
Error in config.tel file.
I am confused, and frustrated ( Network Rookie! ). Any suggestions
would be greatly appreciated.
Thanx in Advance,
Tim
_____________________________________________________________________________
____ ____ ___ Tim Granger
/___ /___/ / / Science Applications International Corporation
____// / / /___ Dayton, Ohio
-----------------------------------------------------------------------------
Internet: Oracle@Dayton.SAIC.COM uucp: uunet!dayvb!Oracle