PHS@acadiau.ca (Paul Steele - Acadia University) (11/29/90)
I am trying to set up Win/Route and Win/TCP so that our users
who are Arcnet can access ethernet telnet services. I installed
Win/Route in a PC with a WD8003e ethernet card and a arcnet card.
I set up interface 1 as the ethernet card at 3/300/c400. Interface
2 was set up as Novell IPX. I gave each interface their own IP
number.
On the Workstation PC I installed WIN/TCP using the IPX interface.
When I load WINTCP.SYS, IPX_DRV, WINTCP, TELNET, and VT100, it
complains that the specified host does not respond when the host
is definately up and running. When I check the interface stats
on the Win/Route PC it indicates that there has been several
successful message receipts but no transmissions. The ethernet
interface shows no activity.
The manual is practically useless for this sort of set up, so
I'm not really sure what I doing wrong. Anyone out there try
this sort of thing?
Paul H. Steele UUCP: {uunet|watmath|utai}!cs.dal.ca!aucs!Paul
Acadia University BITNET: Paul@Acadia
Wolfville, NS Internet: Paul@AcadiaU.CA (131.162.1.51)
CANADA B0P 1X0 (902) 542-2201x587