engwall@mtha.usc.edu (Ralph Engwall) (03/16/91)
I've got an old Ungermann-Bass Ethernet Card with no Docs. It's a full length 8-bit card with a square controller chip made by Fujitsu at the top of the board. It has a 15 pin transceiver cable connector, but no BNC thinwire connector. Is this a PC/NIC board? It doesn't respond to the version 8.x Clarkson packet driver for the PC/NIC. The packet driver gets as far as "Packet Driver is at segment xxxx" and then the machine locks up. I've tried several IRQ and I/O ADDR settings, but no luck. Any knowlageable UB users out hare that can clue me in. -- +-------------------------+-----------------------------------------------+ | Ralph Engwall | Q: Why am I banging my head against the wall? | | engwall@mtha.usc.edu | A: Because it feels *so* good when I stop. | +-------------------------+-----------------------------------------------+
jbvb@FTP.COM ("James B. Van Bokkelen") (03/23/91)
Your card sounds like the PC/NIC, except that the NIC doesn't have any I/O addresses; everything is done via shared memory, so you only need to set that (it uses 32Kb, settable to any 32Kb boundary from 0x80000 to 0xF8000) and an interrupt (2-7). James B. VanBokkelen 26 Princess St., Wakefield, MA 01880 FTP Software Inc. voice: (617) 246-0900 fax: (617) 246-0901