fredv@orion.oac.uci.edu (Fred Velijanian) (06/11/90)
I have been able to install VAX and RISC UWS 2.0 on Wren III and V disks
in the past using several VAXstation 3100's and DECstation 3100's.
However, now I am trying to install RISC UWS 2.2D on a Wren VI disk on a
DECstation 5000, and I have encountered a problem.
The chpt stuff is correctly set to contain the a, b, and g partitions.
I mkfs the a and g partitions using the following commands since the number
of sectors per track is 54 and number of tracks is 15:
/etc/mkfs /dev/rz0a 32678 54 15
/etc/mkfs /dev/rz0g 1197000 54 15
Afterwards, performing an "fsck" results in 2 or 3 errors for each partition:
SPARE FIELDS OF INODE CONTAINED VALUES I=XXXXX
CLEAR?
PARTIALLY ALLOCATED INODE I=XXXXX
CLEAR?
If I ignore the errors or clear them, I encounter problems with setld later
on when it tries to install the required subsets. The error I get is:
"There were fatal verification error for subset UDTBASE031."
Obviously I cannot continue from this point on. If I had cleared the fsck
errors before running setld, there are no fsck errors at this point either.
Any ideas as to how else I should mkfs the partitions?
Thanks for any hints!
Fred Velijanian
Distributed Computing Support
UC Irvine, fredv@vmsd.oac.uci.edu