gerry@swift.cs.tcd.ie (01/16/91)
I am trying to set up an ansi postscript printer to run over a DECserver. The LAT connection works fine, but when I add the postscript entries into the printcap file I get no output at all! I know that it is not a postscript engine just chewing up commands because I hung a dumb terminal on the end of the line and nothing came out either. This is my printcap entry: test|lp3:\ :br#9600:\ :ct=lat:\ :lf=/usr/spool/test_err:\ :lp=/dev/tty03:\ :op=TEST:\ :sd=/usr/spool/test:\ :ts=DSB:\ :uv=psv1.0:\ :ps=LPS:\ :of=/usr/lib/lpdfilters/lpf:\ :Da=ansi:\ :Dl=/usr/lib/lpdfilters/lps_v3.a:\ :Or=portrait:\ :Ss=a4:\ :pw=80:\ :pl=66: Any help would be appreciated. thanks, Gerry O'Brien, Dept. of Computer Science, Trinity College Dublin, Dublin 2, Ireland gerry@cs.tcd.ie