PVR%bgerug51.earn@NSS.CS.UCL.AC.UK (Patrick Van Renterghem / Transputer Lab) (01/31/89)
Suppose you have a large network of transputers and some C004's to switch the links. Is there a utility to program all C004's in the following configuration: ---------- ---------- | 6 T's | | 10 T's | | Board 1| | Board 2| | T2+1 C4|------------------->|T2+2C4's| ---------- ---------- | | B004 First you have to run a program on the first T2/C4 to set up the link to the other board, then run a program on the second T2 to set up the second and third C4. It might even be necessary in some cases to run another program on the first one to change the configuration because you may not want the connection you made in the first place. Solutions ? The second question regards profiling. Would anyone be so kind to send me the source of a profiling task that monitors link activity and processor activity ? Thanks very much in advance. ***************************************************************************** * Patrick Van Renterghem, BITNET: pvr@bgerug51.bitnet * * R&D Assistant, EDU: pvr%bgerug51.bitnet@cunyvm.cuny.edu * * State University of Ghent UUCP: mcvax!bgerug51.bitnet!pvr * * Belgium JANET: PVR%earn.bgerug51@NSS.CS.UCL.AC.UK * * * * Automatic Control Lab/The Transputer Lab, Tel: +32 91 22 57 55 ext. 313 * * State University of Ghent, Fax: +32 91 22 85 91 * * Grotesteenweg Noord 2, * * B-9710 Ghent-Zwijnaarde, Belgium * *****************************************************************************