dmoyer@oiscola.Columbia.NCR.COM (Dan Moyer) (10/25/89)
I acquired a IBM SDLC board from a person that used it some time ago for test evaluation. I want to put it into a PC and run some SNA package that I have, that uses the board. My problem is the previous owner of the board does not have documentation describing strapping options on the board. The part number on the box the board came in is: 1501205. In the PC board, on the back side is 6137396. This is a half size XT compatible bus card, with one rs-23225 pin connector on the lower front of the board. Above the board are two straps labeld P1 and P2. Can anyone e-mail to me how to determine the base address and IRQ setting of this board, and how to change them if necessary so I can insert it into my PC? Thanks in advance