sysop@stech.UUCP (Jan Harrington) (03/28/88)
Perhaps someone who reads this newsgroup can help - I've got a major problem ... I installed a Quadram 386xt board in my Leading Edge Model D. The board works fine, but now TOPS doesn't. The TOPS driver (atalk.sys) is loaded last when the machine boots, so I know it's not being overwritten by any other device drivers. The TOPS software runs perfectly. However, the machine doesn't seem to be talking to the board, since no other nodes on the network are aware that the Leading Edge is alive and the Leading Edge can't see the printers or any of the Macs. I've checked all the cables and everything is tight. Does anybody have any ideas what might be wrong? I don't even know where to start looking ... Jan Harrington, sysop Scholastech Telecommunications UUCP: ihnp4!husc6!amcad!stech!sysop or allegra!stech!sysop BITNET: JHARRY@BENTLEY ******************************************************************************** Miscellaneous profundity: "No matter where you go, there you are." Buckaroo Banzai ********************************************************************************