eddie@WALLY.CC.MSSTATE.EDU (Eddie Mikell) (04/15/89)
I'm not sure if this is an appropriate group to raise these questions to, but I'm certain someone out there can help point me in the right direction anyway. I have a 286 server with a NP600a lan board installed on an ethernet network. I have been attempting to install the netware for the Mac on my server. Things go along fine until I have to tell the server what type of Lan boards I have in it. The only two choices that become available are for a special 3Com board, and a board for some 1000 series (corvus?), neither of which will work (of course) with the NP600 board. Does anyone know if this is the only boards supported for Mac netware? The manual certainly doesn't say so explicitly (their drawings show the Macs and Pc hanging off one ethernet board). One last question. Is there a version of NCSA telnet which will work concurrently with Netware 2.15? Thanks for any and all help. Eddie Mikell eddie@cc.msstate.edu ---------------- ----- End Included Message -----