kieffer@uncanet.BITNET (Rom Kieffer, TransCanada (03/20/91)
greetings, Is it possible to run ka9q over Localtalk to a VAX (with tcp/ip support) via a Gatorbox? I have been using the SLIP support in ka9q very successfully, but I have been unable to run over Localtalk, and I wonder whether I am misreading the instructions in the configuration instructions. I know that packets are sent out to the Localtalk network because they show on the network monitor, mostly as illegal packets, but at least I know that they are sent. I use the following configuration command attach appletalk 7e b arpa at0 600 600 as described in the config info. I can run NCSA telnet/ftp via the localtalk connection to a VAX on one network, and a SLIP connection to a Vax on another network (albeit not simultaneously) so the paths and addressing should be ok. Is there a location where I can pick up a more recent Mac SE/30 version for ka9q? My version still refers to 'Alpha' and is probably more than 2 years old. I was wondering whether there have been any developments that would permit my SE30 to route between two separate networks (136.159... and 142.5...) which is why I have been trying to get the two ports to operate simultaneously. If this can be achieved with another product like NCSA for example, I would like to hear about it. thanks rom