indra@amdcad.AMD.COM (Indra Singhal) (06/02/89)
Apparently this bug did not exist with Elm 1.5b... when sitting in 'answer' with
the Message to: prompt, if you hit <CR> by mistake, it picks up the first person
on your alias list...Oooops !! To me that is a bug, an empty <CR> should just loop
back to the prompt again.
Secondly, if you hit a ^D at that point (when it is prompting for the message)
answer goes into a spin-loop of Message to: prompts. Ofcourse, a ^C is able to
stop it... but a loop... :-(
Any fixes out there?
--
iNDRA | {ames decwrl gatech pyramid sun uunet}!amdcad!indra
| MS 167; 901 Thompson Place; Box 3453; Sunnyvale, CA 94088
| (408) 749-5445