chris@SALT.ACC.COM (Chris VandenBerg) (12/22/88)
Good morning folks.... I've finally gotten my hands on a Toshiba T-3200 and have been running into a bit of a wall trying to get my EXOS-225 card to run it's diagnostics to install in the new beast. I've set the card's MEMBASE to D0000, Int level 2, and IOBASE to 0x310. It runs all the mem diags but is flakey on the subsequent tests, sometimes running, sometimes failing, never getting through unscathed. The only thing I can see is that the case of the T-3200 is REAL tight and the solder side of the board might just be touching the inside of the PC. Has anyone out there gotten this to work? I even went so far as to trim each and every IC leg sticking out the solder side(by hand, no less (:*( ) but all to no avail. I would be truly appreciative for any insights on this subject. Excelan tells me everything should be hunky-dory. Thanks in advance, Chris VandenBerg ACC(chris@salt.acc.com)