[comp.sys.apollo] GNU emacs 18.51 on SR10.1

ram@apolling (M.V.S. Ramanath) (10/21/89)

I'm trying to build Leonard Zubkoff's port of 18.51 on SR10.1. The
first attempt failed in the 'clnz' directory. Since that stuff relates
to the Concept LNZ terminal which I don't need, I tried again after
removing the references to CLNZ, clnz.o, and txtcmp.o in src/config.h.
This time the build succeeded, the executable seems to run perfectly
but when I exit emacs, the window input pad is no longer there and so
the window is completely dysfunctional. Any help is much appreciated.

Ram (imagen!ram@sun.com)

van@tcipro.UUCP (10/24/89)

I recently compiled GNU emacs 18.55 on SR10.1 and ran into the same
problem described by M.V.S. Ramanath, namely that upon exiting emacs
the window it was in became unusable.  I have found that by using the
vt100 terminal emulator, I can get around this problem.  Before
calling up emacs, typing 'vt100' invokes the emulator-- emacs can then
be run and exited normally.  Ctrl-D exits from the emulator.

--Van (van@psych.stanford.edu)