[comp.laser-printers] Cable from 9pin IBM AT to 25 pin Apple LW II NT

mikeo@SKAT.USC.EDU (Mike Orourke) (08/03/89)

	I am trying to make a cable to go from the 9 Pin serial port
of an IBM compatible HP Vectra RS/20 to the 25 pin port of an Apple
Laserwriter II NT.  Does anyone have a schematic diagram showing which
pin on the 9pin side should connect to which pin on the 25 pin Apple
side?  If this is too basic to post over the net please reply
directly.  Any help you could give would be greatly appreciated.

thanks,
Mike O'Rourke
USC