bryanc@pandora.ism.isc.com (Bryan Cote) (04/09/91)
I recently purchased a DL11 Current Loop (20ma) terminal interface for my PDP-11/34. Unfortunatly I did not receive any documentation with this and hence am unable to set the dip switches to a baud rate higher than 2400. The board came pre-configured as a console so I was able to plug-and-play but I am getting tired of the slow response. If someone has the needed information to raise the baud rate I would appreciate it very much. Feel free to E-mail or fax the info to (213)453-1435. Thank you very much in advance. ---------------------------------------------------------------------------- Bryan R. Cote INTERACTIVE Systems Technical Support ----------------------------------------------------------------------------