sbw@tapest.UUCP (Steve Wampler) (02/23/90)
I'm looking for suggestions. I notice that the async_main I'm
running (the 4014 emulation one) knows about 19200 baud (from
a strings of async_main, as well as from simply running it.
However, whenever I try to create a profile - it responds with
an error "Can't open Profiles". (After I've filled in all
the requisite information.)
I hacked a profile by hand (no fun) that I think shows up as 19200
baud, but if I try to dial with it - I get a message that I have
an illegal baud rate, and to use Hardware Setup to reconfigure
the port (which IS set to 19200 baud). I don't know just what
is issuing the bad baud rate message - strings doesn't show it
as coming from async_main.
For the record, I have 3.51m of the OS, but the 3.5 development
set.
Any know how I can really run this async_main at 19200?
Thanks!
--
Steve Wampler {...!arizona!naucse!tapest!sbw}
{...!ditka!tapest!sbw}