kjh@pollux.usc.edu (Kenneth J. Hendrickson) (02/15/90)
This is another hardware question, concerning configuring a 720k drive
as drive B:
In trying various things out, I found the following:
I found a set of pins, which are marked DS and 0 1 2 3.
+++
The jumper goes as shown. On my 1.2M drive, the same set of pins
exists, and I think it is for "device select". I moved the jumper
to the 0 1 2 3 position. I can't try it yet, but I think this is
+++ drive B:.
I also noticed a string of positions for resistors, labeled
A B C D E F G H. There is a resistor only on the A position.
Perhaps I have to move this to B for drive B: ?
If you have any information as to which of these is correct, please
let me know. Thank you.
Kenneth J. Hendrickson N8DGN kjh@usc.edu ...!uunet!usc!pollux!kjh