pda@rsiatl.UUCP (Paul D. Anderson) (07/16/90)
I have obtained 2 Digital H7100A power supplies (100A @ 5v) that I am
planning on using to build a UPS. One of the steps involves raising
the switching supply to provide about 6.5 volts.
After going over the hardware for some hours, I have been unable to
ascertain where the overvoltage circuit is located, although I have been
able to get the voltage up to 5.8 volts- almost there, but not quite
enough.
Does anyone have a schematic on this supply that they could coach me
with or would be willing to part with (or perhaps a photocopy).
Or maybe you have done this and might could tell me a trick about
the hardware. If you could, please email me. I'd sure appreciate it.
Thanks,
-paul
--
* Paul Anderson * Crossroads Computing * (404) 565-0761 * emory!rsiatl!pda *
"SCCS: The condom of promiscuous programmers"