kaser@ee.rochester.edu (Bob Kaser) (02/10/90)
I have a SUN 3/60 with a Micropolus 1355, 141 M, disk drive attached to
the SCSI bus. I also have a Micropolus 1325,71 M,disk that I would like
to connect to the 1355's SCSI out port. The Micropolus 1325 has an
Adaptec(SP) controller.
When we originally purchased this drive we recieved no documentation on
it. What I need to know is: 1) How do I change the SCSI address to 'sd1'
or 'sd2' on the Adaptec(SP) controller. 2) Along with this is, which
jumper block do I change since I don't have any doc's on the drive.
Thanks to all in advance.
Please email the results directly to me.
Why did the Lord give us so much {) kaser@ee.rochester.edu
quickness of movement unless it //\\ {ames,cmcl2,columbia,cornell,
was to avoid responsibility with? ///\\\ garp,harvard,ll-xn,rutgers}!
/\ rochester!ur-valhalla!kaser