saal@floyd.att.com (Sam M Saal) (03/19/90)
I created a document in SunWrite (under SunView) and read in an ASCII file. After spending time correcting formats, fonts, etc, I realized I needed to change some of the "new document settings." I was able to make some of the changes by editing the PostScript file, but I still can't figure out how to convert a single sided document to double sided (back to back print ready - gutter margins will be wider than outer ones). Is there a way to do this in SunWrite? What should I look for/change in the PostScript file itself? I'd appreciate any help on this one. Please send suggestions and comments to me at ...!att!floyd!saal or ...!cbnewsl!saal
bauman@shell.com (Evan Bauman) (03/21/90)
saal@floyd.att.com writes: >I created a document in SunWrite (under SunView) and read in an ASCII >file. After spending time correcting formats, fonts, etc, I realized I >needed to change some of the "new document settings." I was able to make >some of the changes by editing the PostScript file, but I still can't >figure out how to convert a single sided document to double sided (back to >back print ready - gutter margins will be wider than outer ones). You can't change the settings for an existing document that are normally set under "New Document Settings". This includes things like margins. This "feature" is documented somewhere in the SunWrite user's manual. It's very annoying and, for me, is the reason I would buy Framemaker instead of SunWrite. Evan G. Bauman Shell Development Company - Westhollow Research Center PO Box 1380; Houston, TX 77251-1380 bauman@shell.com or for the uucp types: {sun,bcm}!shell!bauman