tony@cns.nyu.edu (Tony Movshon) (08/09/90)
I recently attached an old SCSI shoebox (rescued from a 3/50) to a new SS1+ running SunOS 4.1. The shoebox contains a home-installed Maxtor 2190 (on an Adaptec controller) and an Exabyte 8mm tape drive. Without change of jumper settings, the SS1+ finds the Maxtor disk at sd3, but when it boots it reports the following: sd3: non-CCS device found at target 0 lun 0 on esp0 sd3 at esp0 target 0 lun 0 sd3: <Maxtor XT-2190 cyl 1222 alt 2 hd 15 sec 17> It finds the Exabyte without trouble, and thereafter, everything seems to work fine. Two questions: 1. What does "non-CCS device" mean? 2. Should I worry about it? Tony Movshon Internet: movshon@nyu.edu US Mail: Center for Neural Science, NYU 6 Washington Place, 8th floor New York, NY 10003 Phone: (212) 998-7880