steven@uhunix.uhcc.hawaii.edu (Steven Sakata) (12/05/90)
SYSTEM: Sun 3/60 running SunOS 3.5 connected to a Sun 3/Mass Storage Subsystem PROBLEM: 1) When trying to boot off of the disk, I get the following message: Waiting for disk to spin up 2) When booting off of (and later retension) the tape, I get the following: >b st() Boot: st(0,0,0) scsi:dma never completed st: error=30 sense key=6 scsi:dma never completed st: error=30 sense key=6 Boot: load failed >b st(0,0,100) Boot: st(0,0,100) st: error=18 sense key=1 getbyte error, target never set REQ getbyte error, phase mismatch invalid status msg=FFFFFFFF st: error=30 sense key=6 Device not found > The manuals said the disk message might mean a loose cable connection, but after receding and reconnecting all the cables, still no luck. I couldn't find any explanations for the tape messages. Anyway, these are SCSI devices, and they used to work. The only changes made were the system was physically moved, and more memory was added (and then taken out again after these problems appeared). I would appreciate it if anyone had any ideas on what the problem is. Could the disk have crashed when moved? Steven Sakata (University of Hawaii Computing Center) Internet: steven@uhunix.uhcc.Hawaii.Edu BITNET: steven@uhunix.BITNET