bloomer@rodson.crd.ge.com (John Bloomer) (11/04/90)
As I received no responses about experience with Sun`s FDDI boards, does anybody have ANY FDDI nets with Suns on it? John J. Bloomer <jbloomer@crd.ge.com, uunet!rodson.crd.com!bloomer > KWC317, General Electric Corporate Research and Development, (518)387-6964 PO Box 8, Schenectady NY 12301
carlosp@epone.mcrcim.mcgill.edu (Carlos Perez) (05/10/91)
I need to extend my computer facilities to a place which is about 1/2 a mile away and 21 floors up and I'm thinking of a fiber optics link. The set up in my mind is an FDDI board from Sun, on a SPARC-470 on one end, and a SPARC2 with an FDDI board on the other end. The SPARC2 will be used to boot up several diskless clients and as gateway. All available file systems in my network (40-50) will be NFS-mounted on the diskless machines . I'm aware Ethernet/coax cable will do the job, however soemthing inside tells me to go for fiber -maybe because I don't know much about it-. We use X11 a lot not only for xterms, there are several applications (mostly commercial) that we will not be able to use acroos the net if it wasn't for X11. Thus we have a significant load og graphics across the wire. Now, there are many things that I don't know and for which I'll aprreciate any advise I can get on them. 1. How realiable/debugble/testable is the FDDI/DX controller from Sun? Has anybody out there been using them for a while? 2. How expensive will it be to layout the fiber? I'm located in Montreal, downtown. I assume, there are already lots of pipes underground. I mean percentage-wise, 10%, 20%, 40%? of the total cost of setting this network. 3. Connector receptacles and FDDI connectors have to be from Sun or can be from third parties? 4. How much fiber should be laid and what kind? 5. How can I judge/specify what fiber/receptacle/connector do I need (budget constraints). 6. Is there any third party FDDI board that can be plugged on a SPARC2? 7. Is it a good idea or should I stick to Ethernet and coax. 8. Will bridges (Ethernet/FDDI or coax/fiber) on each site would be a better solution? 9. To re-wire all diskless and the SPARC2 on the remote side, what will be recommendable? o Twisted-pair o Thin-coax o Thick-coax Any idea about the levels of Rf that non-shielded/shielded twisted-pair can produce at 10MHzs and how inmmune to noise it is? Please reply to me and I'll summarize Juan-Carlos Perez, Systems Administrator carlosp@larry.mcrcim.mcgill.edu Research Centre for Intelligent Machines Phone: (514) 398-7155 McGill University, Montreal Fax: (514) 398-7348