jim@piggy.ucsb.edu (Oreo Cat) (10/23/90)
Before I start moaning about my problems, I'd like to repeat a request I've made here a few times before: Does anybody have disks or tapes for Ultrix more current than 1.2 which they would be willing to sell with license for same? I know I could get the most current brand spanking new version from DEC, but the price they charge is not worth it. Since the MicroVax II is 5 years old now I suspect a lot of them have been retired. So if you have or had one of these systems, look around for some disks or tapes collecting dust. They would make my system very happy. Optimally I'd like something with DEC Windows or X11, but I'd be happy with something that works at the moment. Now for my problems: The disks I have weren't quite complete. First of all, the third boot disk was from Ultrix 1.1, and all the other disks from 1.2. Unfortunately this is the disk with the generic kernel on it so that after everything was installed I had a 1.1 kernel, but everything else was 1.2. Still, it booted OK and most things worked. But important kernel specific things like ps don't work. ps is obviously very important, and I've found it very difficult to live without. So I set out to rebuild the kernel and ran into oodles of trouble. First there was no configuration file. Fortunately I was able to write one by hand using some of the instructions in the manual. Then I ran config, switched to the directory and ran make depend, and make. Both worked fine, but when the make got to the "loading vmunix" stage it flaked out with an undefined "_clearseg". I did some probing and found that machdep.o is the file referencing it. I also searched through all the .o files in /sys/BINARY.mvax, and wasn't able to find this cookie in any of them. I suspect it's another file that some how vanished from the disks. Anyone have any ideas on this one? Well, compared to this, all of my other problems are fairly minor, so I won't go into them now. Thanks in advance for any help! Jim Lick Work: University of California | Home: 6657 El Colegio #24 Santa Barbara | Isla Vista, CA 93117-4280 Dept. of Mechanical Engr. | (805) 968-0189 voice 2311 Engr II Building | (805) 968-1239 data 1 (805) 893-4113 | (805) 968-2734 data 2 jim@ferkel.ucsb.edu | bahamut!jim@ivucsb.sba.ca.us