peter@stcns3.stc.oz (Peter Jeremy) (06/03/88)
I am trying to get RN running on my 80286 under Xenix. During the process of shoehorning it into small model (64kI + 64kD), I have run into a couple of problems: 1) defining VERBOSE without TERSE causes some 'verbose undefined' error messages in several files due to the use of 'if' and 'else' instead of 'IF' and 'ELSE'. These I have fixed. 2) attempting to undefine PUSHBACK results in pushchar() becoming undefined, although it is still used by art.c ng.c rcstuff.c rn.c. Has anyone else run into this problem? Can I fix it by altering term.c so that pushchar (and its associated data arrays) are defined outside the #ifdef PUSHBACK/#endif block, or will this break something else? I think I'm only just over 64kI, so I would prefer to keep squeezing rather than go to a larger model (the linker is very unhelpful about segment overflow problems). The code I have is RN version 4.3, patchlevel 40. If/When I get it running, I will post the necessary changes (there are quite a few necessary to Configure). -- Peter Jeremy (VK2PJ) ACS: peter@stcns3.stc.OZ Alcatel-STC Australia ARPA: peter%stcns3.stc.OZ.AU@uunet.UU.NET Gnd Floor, 41 Mandible St, UUCP: {enea,hplabs,mcvax,uunet,ukc}!\ Alexandria NSW 2015 AUSTRALIA munnari!stcns3.stc.OZ.AU!peter