[comp.sys.intel] iPDS EMV51A Emulation Vehicle

spalding@uiucdcsp.cs.uiuc.edu (05/29/88)

Running the MCS-51 Emulation Vehicle on the iPDS, how do I
refer to PL/M-51 line numbers to set breakpoints etc.  The PL/M-51
documentation says I can do this, but the EMV51A documentation
doesn't say how.  I'm getting the symbols (procedure names, labels)
ok.  I just need an example of the syntax for specifying line numbers in
EMV51A commands.  BTW, this is EMV51A version 1.2.

Thanks,
John W. Spalding
spalding@p.cs.uiuc.edu