terry@eecea.eece.ksu.edu (Terry Hull) (04/15/89)
Sorry to bother everyone with this again, but I'm still having some trouble with handshaking through my TB+. I am not having any problems with uucp, but when I dial into the system for an interactive session, I can set ctsflow OK, but when I type stty rtsflow, everything locks up as if the computer is not getting any input. Yes, I have installed the RTS/CTS patch from SCO. Configuration info: Digiboard 4/S dumb 4-port serial board. Cable 2-8 and 20 straight through Modem config Interface speed locked at 19200 Dialing in at 1200 buad RTS/CTS enabled (S58=2) S68=255 (makes modem expect both ends to do same handshaking) /etc/gettydefs entry: n # EXTA HUPCL # EXTA CS8 SANE IXON TAB3 ECHOE IXANY # rest of entry Two other really strange things: I have seen both rtsflow and ctsflow enabled when doing a uucico to another TB site. I am using the dialTBIT executable to dial out. (But obviously, it does not have any affect on my incoming call.) Secondly, if I dial out using XON/XOFF and then enable RTSFLOW, my machine will stop sending characters to the serial port. I am lost. Why does RTS/CTS work some time and not the rest of the time? Any ideas that you have would be appreciated. -- Terry Hull Department of Electrical and Computer Engineering, Kansas State University Work: terry@eecea.eece.ksu.edu, rutgers!ksuvax1!eecea!terry Play: tah386!terry@eecea.eece.ksu.edu, rutgers!ksuvax1!eecea!tah386!terry