[comp.unix.xenix] Need Info on a 33MHZ PC to run Xenix 386

VIC_F_DUGURAN@cup.portal.com (05/31/89)

Hello!, We need some info on what harware will support the following specs,
or if anybody can point us to a vendor/s that can provide them, please 
email the reply, thanks!.



	A: Hardware(Basic):
		
		1. "PC", Intel 80386 CHIP Based, 33 MHz, "TOWER"
		   Configuration, with the following specs:

			a. 8 MB (60 ns) Memory, Exp. to 16 MB.
			b. 8.0 MIPS Minimum.
			c. Dual Bus Architecture w/64 Bit
			   Internal Cache Bus, with 128 KB (25ns)
			   Static RAM.
			d. Shadow RAM Cache Memory.
			e. 1.44 MB FLoppy (3-1/2").
			f. 1.2 MB Floppy (5-1/4").
			g. Minimum of 1 Serial and 1 Parallel Port.
			h. High (800x600) Res. Mono Monitor w/ VGA.
			i. 150 MB HD w/Second HD Capability(Full).
			   32 KB Disk Cache. 1.875 KB/Sec Xfer Rate.
			   20 ms Min. Access time and 1:1 inter-
			   leaving with full track buffering.
			j. Intel 32 Bit 80387 Coprocessor Support
			   with 33 MHZ System Clock.

	B. Hardware(Networking):

		1. Intelligent Networking Hardware to support SCO
		   Xenix 386 OS Multiuser Environment.

			a. 16 Bit Controller w/8 Mhz Processor and
			   64K RAM Offloading I/O processing from 
			   main processor w/4 terminal concentrator
			   ports.

			b. 2 Terminal Concentrators w/16 RS232 port
			   capability and 6 MHz processor, attachable
			   to controller card concentrator ports.

			c. Thin twisted pair wire connection from
			   terminal concentrator to ascii terminals
			   and PCs.

	C. Hardware(Satellite), (Quantity of 8 Units):

		1. ASCII Terminals Complete with all necessary hardware
		   to connect to basic Network "B" above.

			a. 78 Hz Refresh Rate.
			b. 110 Vac.
			c. 2 serial ports, 1 parallel port. 


vic_f_duguran@cup.portal.com
Saipan Computer Services
Caller Box PPP 1011
Saipan, MP 96950

FAX: (670) 234-9119