macy@fmsystm.UUCP (Macy Hallock) (09/23/89)
Well, I downloaded xnx130 from sosco, which is the new Irwin driver software, and installed it. (Yes, I know its on hold again, but that's just for write protect recognition only) Now - I can't use the tape drive. I get I/O error messages from the driver. I am using a known good (under MS-DOS w/EZTAPE 2.01) 125 drive, with an Adaptec 2372A controller with the 125 as floppy position 2. I either need this fixed, or a way to return to the original Irwin stuff in the 2.3.1 release. (What do I delete/reinstall? Can I do it w/custom?) I had this working, before I decided to "improve" and "upgrade". All my earlier backups are in this original SCO Irwin format on DC-1000 tapes. All I have on floppy is the original installation diskette set. I've been fighting with this on and off for a month and I'm licked. Anyone know the answers? Regards, Macy Hallock fmsystm!macy@NCoast.ORG F M Systems, Inc. hal!ncoast!fmsystm!macy 150 Highland Dr. uunet!hal.cwru.edu!ncoast!fmsystm!macy Medina, OH 44256 Voice: 216-723-3000 X251