root@ozdaltx.UUCP (root) (02/21/90)
My knowlege about graphics is pretty limited, so here goes: I have several callers who are telling me that if they access a certain program on the board, that in EGA mode they see one type of ANSI graphic character, but in VGA mode they see a different set of characters. Same program, same termcap - nothing changed except their mode. Is there that much difference between the two? Is there anything I can do from my end to eliminate this difference or is it up to them? I can't check it out as I have a plain-jane ansi, amber monitor, so things look fine to me. We're running SCO XENIX, ver 2.2.3 on a 286. I think one caller is running 386 Xenix and the others are using DOS. Any ideas, comments, suggestions would be appreciated. thanks in advance.... Scotty -------- AIDS INFORMATION EXCHANGE BBS (214) 247-2367/247-5609 "Education is the best weapon" {ames,rutgers,texsun,smu}!attctc!ozdaltx!sysop