sl@van-bc.wimsey.bc.ca (Stuart Lynne) (08/24/90)
The SCO Xenix GT doc's explicitly state that you cannot have a SCSI boot disk and a regular hard disk controller in the same system. This does work however if the regular hard disk controller is addressed at the second hard disk controller location. The trick is that you may have to build the /dev/entries yourself. I had working RLL drives already on the second controller and just wanted to swap the main ESDI for a SCSI leaving them in place. Just made the device entries and it seems to work fine. I suspect that just using: mkdev hd 0 1 and telling the script that your boot controller is ST506 will work to add an ST506 controller (addressed as the second controller) to a SCSI based system. -- Stuart.Lynne@wimsey.bc.ca ubc-cs!van-bc!sl 604-937-7532(voice)